Custom harnesses available

C. Ludwig · 01-07-2009, 11:03 AM

We've built a few custom harnesses that we've shipped to customers for them to install. We can terminate all of the underhood connections and usually only leave the power connections for the ECU and fuel pump for the customer to finish. The cost starts at $300 for an FC harness if the ECU flying lead kit is purchased from us at the same time. FD harnesses are more complex and start at $400 for a single turbo harness. We use Raychem heat shrink and braided nylon sheath. All butt connections are soldered and double heat shrunk. Terminals are properly crimped. Below are some pics of a harness built for an FD using an Electromotive Tec3r.

01-07-2009, 11:03 AM	#1
C. Ludwig Rotary Masochist Join Date: May 2008 Location: Floyds Knobs, IN Posts: 494 Rep Power: 18	Custom harnesses available We've built a few custom harnesses that we've shipped to customers for them to install. We can terminate all of the underhood connections and usually only leave the power connections for the ECU and fuel pump for the customer to finish. The cost starts at $300 for an FC harness if the ECU flying lead kit is purchased from us at the same time. FD harnesses are more complex and start at $400 for a single turbo harness. We use Raychem heat shrink and braided nylon sheath. All butt connections are soldered and double heat shrunk. Terminals are properly crimped. Below are some pics of a harness built for an FD using an Electromotive Tec3r. __________________ _______________________________________________ *One stop Haltech, AEM, Syvecs shopping. Installation and tuning.* http://www.lms-efi.com *Free support. Drop us an email.* chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI