Small vs mild vs large streetport

NoDOHC · 05-03-2009, 07:49 AM

If you go too big with the street port, your intake manifold will become your primary restriction. If you go too small, the engine can't breathe. From what I am told, you want the intake tract on the engine to remain the same cross-sectional area throughout. If anything, the port should be slightly smaller than the intake runner.

Basically street manners are completely determined by port timing. If you extend the port downwards too much, it will not idle well. Upwards hurts your starting and low-end torque.

The minimal street port that I have on my 4-port was designed to leave port timing completely stock, but to close the port more abruptly (better dynamic tuning) and allow for additional cross-sectional area to support my 1.42" primary and 1.68" secondary intake runners.

It idles rock-solid and does not stall at launch (110 Wlb-ft at 1000 rpm by g-tech). It really doesn't start to pull until 3500 (pulls the tires loose) and it comes alive at 5500 (weeee).

I will post power numbers when I get a chance to go to the dyno.

05-03-2009, 07:49 AM	#7
NoDOHC The quest for more torque Join Date: Sep 2008 Location: Sheboygan, Wisconsin Posts: 855 Rep Power: 17	If you go too big with the street port, your intake manifold will become your primary restriction. If you go too small, the engine can't breathe. From what I am told, you want the intake tract on the engine to remain the same cross-sectional area throughout. If anything, the port should be slightly smaller than the intake runner. Basically street manners are completely determined by port timing. If you extend the port downwards too much, it will not idle well. Upwards hurts your starting and low-end torque. The minimal street port that I have on my 4-port was designed to leave port timing completely stock, but to close the port more abruptly (better dynamic tuning) and allow for additional cross-sectional area to support my 1.42" primary and 1.68" secondary intake runners. It idles rock-solid and does not stall at launch (110 Wlb-ft at 1000 rpm by g-tech). It really doesn't start to pull until 3500 (pulls the tires loose) and it comes alive at 5500 (weeee). I will post power numbers when I get a chance to go to the dyno. __________________ 1986 GXL ('87 4-port NA - Haltech E8, LS2 Coils. Defined Autoworks Headers, Dual 2.5" Exhaust (Dual Superflow, dBX mufflers) 1991 Coupe (KYB AGX Shocks, Eibach lowering springs, RB exhaust, Stock and Automatic)