1st Gen/RX8 motor/trans install

[Phoenix7]

I think this swap will have the same hurdles as any other 8 swap:

-custom mounts for engine and/or tranny
-a new dash or the 8 dash so it all plugs in and works (no need for a standalone) don't know if you can use a HUD system with the stock 8 stuff, never seen it done....
-look into the length of the tranny too, in case you need to cut into the tranny well....then the DS in case it needs to be custom to fit

Never seen anyone do a write-up on this so if you end up doing more research please post your findings.