$400 gsl-se

TaylorI · 01-20-2010, 10:58 PM

No work on the SE so far but I did work. Me and my dad started building a little workshop for me, so my stuff is not in the way of his stuff.

stuff that was in that little tiny garage and my dad

my stuff in the way

In the little area I'll have enough room to work on any engines and to weld/fab etc. plus I'll have a nice clean work bench setup with a laptop muahaha. yay me.

and my dad cutting work bench.

Hopefully at the end of the week I'll be done wood working and continue metal working haha. Well except my SAT's are saturday. 2250?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-20-2010, 10:58 PM	#1
TaylorI Rotary Fan in Training Join Date: Dec 2009 Posts: 37 Rep Power: 0	No work on the SE so far but I did work. Me and my dad started building a little workshop for me, so my stuff is not in the way of his stuff. stuff that was in that little tiny garage and my dad my stuff in the way In the little area I'll have enough room to work on any engines and to weld/fab etc. plus I'll have a nice clean work bench setup with a laptop muahaha. yay me. and my dad cutting work bench. Hopefully at the end of the week I'll be done wood working and continue metal working haha. Well except my SAT's are saturday. 2250?