|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|
07-16-2010, 09:45 AM
|
#9 |
|
destroy, rebuild, repeat
Join Date: Feb 2008
Location: Charleston, SC
Posts: 395
Rep Power: 18  |
well i replaced the gasket, still have the leak.. the engine-to-manifold gasket looked good to me, but i guess ill try replacing that next. it is a dual bearing center
the one problem i did notice is the garrett "top hat" looking thing on the exhaust side has a thicker lip than stock, and i think it may be causing the leak. If i did it again, i would use the stock piece
__________________
1993 RX-7 Touring MB, stockport 13B-REW, 9.4CR rotors, T04S 60-1/p-trim single turbo 1986 RX-7 Base project track beast Last edited by 88turboii; 07-16-2010 at 09:50 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode