Component tweeter installation locations on an FC

JustJeff · 11-02-2010, 09:17 PM

Pete

If I were you I'd fab up something out of fiberglass resin. First cut and tape some cardboard in the shape that will work best for you. Then paint the resin on it with some woven fiberglass. Leave the back that will contact the trim open. Once it's hardened you can take a dremel bit and sand out the cardboard. You can cut a hole for your tweeter and lay some vinyl that matches the interior.

Thats how I was considering doing mine. Then I realized the pods face the tweeters perfectly. That's when sinking one screw each through my door panels was alot more convenient than fabbing up a panel.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-02-2010, 09:17 PM	#12
JustJeff RCC Contributor Join Date: Mar 2008 Posts: 505 Rep Power: 18	Pete If I were you I'd fab up something out of fiberglass resin. First cut and tape some cardboard in the shape that will work best for you. Then paint the resin on it with some woven fiberglass. Leave the back that will contact the trim open. Once it's hardened you can take a dremel bit and sand out the cardboard. You can cut a hole for your tweeter and lay some vinyl that matches the interior. Thats how I was considering doing mine. Then I realized the pods face the tweeters perfectly. That's when sinking one screw each through my door panels was alot more convenient than fabbing up a panel.