|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
Thread Tools | Display Modes |
![]() |
#11 |
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
Just did a car this morning, swapped out Inductive for full CDI system, and better idle.......... so go figure
![]() I think the point is with all of this (and I have seen it before across many times repeated tests) you cant take a one off "bad experience" as a case for all, as I said not all are equal. I do know that I personally have never seen a CDI make the same power as an inductive, its always been a big + increase to the CDI system ![]() TTT I too had a bad experience with CDI's a few times over the years, but then I learned myself about electrics and bought my own equipment to test it, and sorted the shit from clay ![]() ![]() I'll take some pics of the Mazda test and post them for you mate.
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|