|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
04-17-2011, 06:05 PM
|
#2 |
|
Home-brew Rotary
Join Date: Feb 2008
Location: GooseCreek SC
Posts: 552
Rep Power: 18  |
Replace both bearings.
Send them to a rotary builder to get those bearing replaced, If your not experienced with that. Btw, you left the oil control rings and some side seal springs in there. 
__________________
'89 RX7 GTU, half-Bridge-port S4/S5 NA, E6K, Full RB exhaust, weekend warrior. '83 RX7, The "this might take awhile" project. '87 RX7 GXL, Rest In Pieces. '98 Subaru Impreza Outback-sport, rx7 rescue vehicle, down for repair. '94 Ford Ranger, daily. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode