Shotgun rebuild

[RETed]

Originally Posted by Ender

This is the one, you can't tell well because it's blurry, but it's very obvious on both sides that whatever disc they used slipped.

Okay, the pics are that bad that I'm not quite sure what you're trying to describe?

The two later ones with the stat gears are fine.
The copper showing on the *seam* of the bearing is okay.

I'm not too sure what is wrong with the bearing on the rotor is?
If anything it looks like it slipped out a little?
If so, you can just press it back in; just make sure the "tab" is aligned correctly.
Else, I don't see any major copper areas showing.


-Ted