Twin Charged FD - Fraternal Twins

RX SE7EN · 11-10-2011, 11:34 PM

Added a mounting tab to the intercooler for its test fit (only tacked on right now). It turned out pretty well, so now I'll add two more tabs to secure it in place.

Lots of room for piping, and it's slightly tilted so I won't need 90 degree entries into the cooler:

With the bumper on. The ductwork will connect it to the bottom of the radiator, and fresh air will go around the sides and directly into the radiator, with ducting to make it so it can't escape before it hits the radiator.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-10-2011, 11:34 PM	#11
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Added a mounting tab to the intercooler for its test fit (only tacked on right now). It turned out pretty well, so now I'll add two more tabs to secure it in place. Lots of room for piping, and it's slightly tilted so I won't need 90 degree entries into the cooler: With the bumper on. The ductwork will connect it to the bottom of the radiator, and fresh air will go around the sides and directly into the radiator, with ducting to make it so it can't escape before it hits the radiator.