|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
11-29-2011, 02:38 PM
|
#7 |
|
Rotary Masochist
Join Date: May 2008
Location: Floyds Knobs, IN
Posts: 494
Rep Power: 18  |
- Bore the fuel rail to 14mm. Drill is ok, ream is better. You'd like a smooth finish that doesn't snap and tear o-rings.
- Go down to the local hardware store and get a pair of E-clips that snap on to the top of the Bosch injectors in the little slots. These will keep the injector from pushing into the rail too far. - Pop the pintle cap off the bottom. Slide new stock grommets on to the injector. - Bolt it all together.
__________________
_______________________________________________ One stop Haltech, AEM, Syvecs shopping. Installation and tuning. http://www.lms-efi.com Free support. Drop us an email. chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode