Twin Charged FD - Fraternal Twins

RX SE7EN · 12-01-2011, 10:15 PM

Treated myself to a day off of work to work on the car yesterday. Got quite a bit done!

Finished up the thermostat housing and waterpump housing, cleaned it up quite a bit.

Cut a piece out of the left over 1/2" plate that I used for the throttle body flange, drilled the mounting holes and then drilled a hole in the center for the hole saw:

Hole saw action:

And a -16 AN bung

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-01-2011, 10:15 PM	#11
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Treated myself to a day off of work to work on the car yesterday. Got quite a bit done! Finished up the thermostat housing and waterpump housing, cleaned it up quite a bit. Cut a piece out of the left over 1/2" plate that I used for the throttle body flange, drilled the mounting holes and then drilled a hole in the center for the hole saw: Hole saw action: And a -16 AN bung