Twin Charged FD - Fraternal Twins

RX SE7EN · 12-01-2011, 10:28 PM

Cut and ground down a lot of the water pump housing. Now I've got a -16AN for the lower radiator hose, -10AN for the heater core hose, and a -4AN on top for the new AST. I also added a 1/8npt bung to relocate the sensor for my gauge.

Installed:

Everything still clears:

Here's my custom AST, made out of a $20 catch can from ebay, a few bungs, and a billet pressure cap holder.

What it started as:

What it is now:

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-01-2011, 10:28 PM	#11
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Cut and ground down a lot of the water pump housing. Now I've got a -16AN for the lower radiator hose, -10AN for the heater core hose, and a -4AN on top for the new AST. I also added a 1/8npt bung to relocate the sensor for my gauge. Installed: Everything still clears: Here's my custom AST, made out of a $20 catch can from ebay, a few bungs, and a billet pressure cap holder. What it started as: What it is now: