Craig's Project JDM FD3S UK Style

Topgear · 12-13-2011, 04:06 PM

Well guys

I've always liked the look of the dolphin tail exhaust systems.

So I'm developing a catback system which I can make to order once all development and testing have been completed

We will also be adding the mid-pipe and silenced mid-pipe at a later date

The spec will be 3" bore using 8x5" oval silencer and 4" mandrel 45 deg tail in plain or burnt tip

Below is the master system from which the other systems will be made from jigs

All systems will be T304 stainless and hand tig welded so all systems will be made from hand.

It's early days but what's your guys inputs on this design

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-13-2011, 04:06 PM	#9
Topgear Rotary Fanatic Join Date: Feb 2011 Location: UK Posts: 266 Rep Power: 15	Well guys I've always liked the look of the dolphin tail exhaust systems. So I'm developing a catback system which I can make to order once all development and testing have been completed We will also be adding the mid-pipe and silenced mid-pipe at a later date The spec will be 3" bore using 8x5" oval silencer and 4" mandrel 45 deg tail in plain or burnt tip Below is the master system from which the other systems will be made from jigs All systems will be T304 stainless and hand tig welded so all systems will be made from hand. It's early days but what's your guys inputs on this design