FPR Kits?

rotorlips · 02-23-2012, 09:41 AM

ok. this is quite simple then . grab some braided -6 line for the fuel. you can get the fittings from jegs or summit that will screw right into both factory rails .makes for a nice clean install . braided line will go right to fuel filter and fuel return. get an sx engineering regulator 1:1 ratio for boosted motor. set pressure same as stock . youll be good to go. stock rails are quite good so no need to worry there .hope that helps. used many systems like this on many 2nd gens.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-23-2012, 09:41 AM	#4
rotorlips The Newbie Join Date: Feb 2011 Posts: 25 Rep Power: 0	ok. this is quite simple then . grab some braided -6 line for the fuel. you can get the fittings from jegs or summit that will screw right into both factory rails .makes for a nice clean install . braided line will go right to fuel filter and fuel return. get an sx engineering regulator 1:1 ratio for boosted motor. set pressure same as stock . youll be good to go. stock rails are quite good so no need to worry there .hope that helps. used many systems like this on many 2nd gens.