|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
03-14-2012, 12:06 PM
|
#18 |
|
Gold Wheels FTW
Join Date: Mar 2008
Posts: 744
Rep Power: 18  |
They're using inserts in the apex seal grooves, but not the side seals. So they may still have a galling problem. I would have to agree though that TI is probably not the best material. I'd rather use a heat treated AL, or keep the outer casing a cast iron and make the guts out of a lot lighter material.
__________________
My Cars: 1974 RX4 Coupe 1991 FC3S RX7 - Sold 2003 ZZW30 MR2 (Rotary swap after RX8) 2004 SE3P RX8 (20B Swap in the works) |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode