How to remove flywheel?

Force13b · 03-21-2012, 12:39 PM

I've seen people get them off with a heavy duty impact driver and no flywheel lock.

t_g_farrell · 03-21-2012, 12:44 PM

I took some 2" angle iron, drilled holes to match the engine mount holes
on the front cover and bolted it on to stabilize the engine to get the front
bolt out of the eccentric shaft.

You can probably do the same trick with the angle iron on the flywheel as well.

03-21-2012, 12:44 PM	#2
t_g_farrell Waffles - hmmm good Join Date: Aug 2008 Location: Huntersville, NC Posts: 757 Rep Power: 0	I took some 2" angle iron, drilled holes to match the engine mount holes on the front cover and bolted it on to stabilize the engine to get the front bolt out of the eccentric shaft. You can probably do the same trick with the angle iron on the flywheel as well. __________________ 1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs Project Fat Nikki Budget 12A rebuild Video setup < $30.00

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-21-2012, 12:39 PM	#1
Force13b cxxxx\|::::::::::::> Join Date: Nov 2009 Posts: 315 Rep Power: 16	I've seen people get them off with a heavy duty impact driver and no flywheel lock.