Carb'd 12A 1985 AE86 Coupe build in the Lonestar State

dr.occa · 05-18-2012, 10:23 PM

OMP adapter kit installed. Yay!

Lines to the intake manifold via 90 degree 1/8" barb to 1/8" npt fittings.

The clear lines are a 4mm ID/6mm OD, crack-resistant Teflon hose. The hose is a very snug fit on the 12A OMP nipples and 1/8 barbs fittings. They'll hold up well against the pre-mix solution. The pre-mix reservoir bracket is next on the list and then a longer linkage to hook the OMP up to the throttle lever of the IDA.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-18-2012, 10:23 PM	#28
dr.occa Rotary Fan in Training Join Date: Mar 2011 Posts: 73 Rep Power: 15	OMP adapter kit installed. Yay! Lines to the intake manifold via 90 degree 1/8" barb to 1/8" npt fittings. The clear lines are a 4mm ID/6mm OD, crack-resistant Teflon hose. The hose is a very snug fit on the 12A OMP nipples and 1/8 barbs fittings. They'll hold up well against the pre-mix solution. The pre-mix reservoir bracket is next on the list and then a longer linkage to hook the OMP up to the throttle lever of the IDA.