Tegheim - Home made 4 rotor Wolvo 142

Tegheim · 07-07-2012, 11:33 AM

I recieved a rod yesterday, Delrin, for bushings. My wife is happy with me as I am

Coming to these using a stainless steel sleeve model 16x2mm.

This is what it would look like, as common.

Then today I got to work hard because I do not have access to laser-cutter. Began to mill as deep as I dared, without them to come off, and the plate begins to vibrate and break the cutter. Then there has been much handwork! Good for me, to practice a bit. Continued on these!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-07-2012, 11:33 AM	#11
Tegheim Rotary Fanatic Join Date: Feb 2011 Posts: 210 Rep Power: 15	I recieved a rod yesterday, Delrin, for bushings. My wife is happy with me as I am Coming to these using a stainless steel sleeve model 16x2mm. This is what it would look like, as common. Then today I got to work hard because I do not have access to laser-cutter. Began to mill as deep as I dared, without them to come off, and the plate begins to vibrate and break the cutter. Then there has been much handwork! Good for me, to practice a bit. Continued on these!