New From Tennessee

reddozen · 08-14-2012, 11:28 AM

If I had to guess, I'd say close to $5k, but that all depends on the setup, and since it's a 1 off billet, it could be as much as $10k. Most CAD quotes I've gotten alone for manufacturing / engineering are in the $3000~$5000 range, and that's just for a cast rotor. I had them spec out my 3rotor shaft and it's about the same general cost, but cheaper to actually cast at around $200 a slug.

GL, I'll be curious to see what they quote you...

08-14-2012, 11:28 AM	#10
reddozen Gold Wheels FTW Join Date: Mar 2008 Posts: 744 Rep Power: 18	If I had to guess, I'd say close to $5k, but that all depends on the setup, and since it's a 1 off billet, it could be as much as $10k. Most CAD quotes I've gotten alone for manufacturing / engineering are in the $3000~$5000 range, and that's just for a cast rotor. I had them spec out my 3rotor shaft and it's about the same general cost, but cheaper to actually cast at around $200 a slug. GL, I'll be curious to see what they quote you... __________________ My Cars: 1974 RX4 Coupe 1991 FC3S RX7 - Sold 2003 ZZW30 MR2 (Rotary swap after RX8) 2004 SE3P RX8 (20B Swap in the works)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode