Intake Design Exploration

vex · 10-06-2012, 12:07 PM

There's been progress on this topic; I just have not been able to get back to it in a very timely manner. As a teaser: Here is a quick and dirty of a prototype intake manifold under CFD testing. I have forgone the use of a diffuser for this run; just to ensure that if I can get a uniform flow at the entrance of the manifold I get a good flow at the runners:

Here's the initial design:

notice the poor flow distribution to the runners. This required me to alter the geometry of the plenum.
Here's the final prototype:

10-06-2012, 12:07 PM	#33
vex RCC Loves Me Not You Join Date: Jul 2008 Location: Influx. Posts: 2,113 Rep Power: 20	There's been progress on this topic; I just have not been able to get back to it in a very timely manner. As a teaser: Here is a quick and dirty of a prototype intake manifold under CFD testing. I have forgone the use of a diffuser for this run; just to ensure that if I can get a uniform flow at the entrance of the manifold I get a good flow at the runners: Here's the initial design: notice the poor flow distribution to the runners. This required me to alter the geometry of the plenum. Here's the final prototype: __________________ The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode