AutoEXE 20b GTX-R 4294 DrySump RE-A ADGT Widebody

MotoTek · 01-31-2013, 07:43 PM

Reaming of oil feed passages on the irons to the stationary gear bearings for increased oil flow; done by Chips Motorsports!
-8 with o-ring groove for a leak proof setup, not pipe threaded like other builders out there.

Because I'm also running a Mazdaspeed dry-sump system Chip will be doing some trick stuff that I'll post later, so stay tuned for some rotary related porn that you've never seen done to a rotary before!

01-31-2013, 07:43 PM	#33
MotoTek Always Under Construction Join Date: Mar 2008 Location: La Playa, CA Posts: 302 Rep Power: 18	Reaming of oil feed passages on the irons to the stationary gear bearings for increased oil flow; done by Chips Motorsports! -8 with o-ring groove for a leak proof setup, not pipe threaded like other builders out there. Because I'm also running a Mazdaspeed dry-sump system Chip will be doing some trick stuff that I'll post later, so stay tuned for some rotary related porn that you've never seen done to a rotary before! __________________ BLACKADDE™ \| ADGT RX7 \|

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode