Mitchocalypse build V2

[speedjunkie]

Originally Posted by Mitchocalypse

I bought them locally but i can tell you exactly what they are. I'm sure theres an easier and cheaper way to go about getting the exact same thing but i just went off what they had in stock.

the top is a typical 90 hose end (don't have hose in mine yet obviously)

then the female end is on the short end of this bulkhead adaptor:

then i got one of these for each connector, there was one hex nut on each that came off and the 2 nylon washers.. took that stuff, trashed the actual fitting. (like i said, i'm sure theres a more cost effective way)

then the bottom is this:

You can guaranteed get all these pieces from summit racing but if you're ordering online, i'm sure theres a much cheaper way around it.. each unit cost me over 70 bucks.. which is robbery.

Oh and i should add, if you're doing this, you might also consider getting some electrical bulkhead connectors like these ones that summit sells

to do a nice clean fuel pump wire. Just got mine today!

Originally Posted by Fendamonky

Lookin' really good Mitch! Hopefully you can have her all buttoned up in time for driving season



Summit Racing also sells 90° bulkhead connectors.

- -8 bulkhead fitting, 90deg Aeroquip Bulkhead Adapter Fittings FBM2794 $16.95
- -6 bulkhead fitting, 90deg Aeroquip Bulkhead Adapter Fittings FBM2793 $9.95

I believe the two above fittings are for AN hose ends on either side, not a fuel line connection, though.

Thanks for the info, guys!

[Mitchocalypse]

Body work is wrapping up.
Here are the parts painted off the car. The rest of the car goes in tomorrow.