pressure plate...

jimstaz · 03-20-2013, 06:23 PM

I orginaly put a stage two clutch in and things went smooth.. then it wouldn't go into gear.. so later I sent it to a whole in the wall shop and they replaced the actual clutch again.. with new factory crap... I got to drive it 60 miles then it wouldn't go into gear... now my disk got shreaded some home.. I pulled my stater out and there was Kevlar everywhere.. so I clean it out.. wqhere the starter was and it started up and all you hear is the disk inside flapping... don't get it..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-20-2013, 06:23 PM	#5
jimstaz Rotary Fan in Training Join Date: Jul 2011 Location: clarksville, tn Posts: 87 Rep Power: 15	I orginaly put a stage two clutch in and things went smooth.. then it wouldn't go into gear.. so later I sent it to a whole in the wall shop and they replaced the actual clutch again.. with new factory crap... I got to drive it 60 miles then it wouldn't go into gear... now my disk got shreaded some home.. I pulled my stater out and there was Kevlar everywhere.. so I clean it out.. wqhere the starter was and it started up and all you hear is the disk inside flapping... don't get it..