Great, another V8 FC drift car build thread :/

StephenSheppard · 03-23-2013, 10:44 PM

Started building this cover for the fuel stuffs. It's all one piece that is removed by undoing 8 little M5 bolts at the base and lifting up. It is fully enclosed even though some of the pics don't show it. All aluminium, even the rivets lol. weighs like 2 lbs.

inside

New vent hose before the tank goes back in.

I was really worried about the clearance to this feed hardline, but as you can tell there's no issue at all.

New hoses and stuff for the vent/rollover valve thingy. Cause why not?

Fits so good. I love it.

This moth picked the worst place ever for a vacation.....just saying.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-23-2013, 10:44 PM	#29
StephenSheppard Rotary Fan in Training Join Date: Nov 2012 Posts: 58 Rep Power: 13	Started building this cover for the fuel stuffs. It's all one piece that is removed by undoing 8 little M5 bolts at the base and lifting up. It is fully enclosed even though some of the pics don't show it. All aluminium, even the rivets lol. weighs like 2 lbs. inside New vent hose before the tank goes back in. I was really worried about the clearance to this feed hardline, but as you can tell there's no issue at all. New hoses and stuff for the vent/rollover valve thingy. Cause why not? Fits so good. I love it. This moth picked the worst place ever for a vacation.....just saying.