2 questions, clutch bleeding

a7xh7 · 05-12-2008, 06:21 PM

i ended up getting a motive pressurized bleeder(45mm / euro adapter fits perfect, get the billet cap its worth it

). works good the cap is a bit tricky to get sealed, it needs to twist around a lot more times than u would think. also the hose connector to the cap wasn't tightened properly so it was leaking a but there, so check that if anyone gets one..

so after going through the process.. my clutch still has the play AND is super stiff. not sure what went wrong of if my slave went out during the process. i only applied 12psi to the system. not sure what to do next.. trying to see what may have happened..

05-12-2008, 06:21 PM	#5
a7xh7 Rotary Fan in Training Join Date: Mar 2008 Posts: 88 Rep Power: 0	i ended up getting a motive pressurized bleeder(45mm / euro adapter fits perfect, get the billet cap its worth it ). works good the cap is a bit tricky to get sealed, it needs to twist around a lot more times than u would think. also the hose connector to the cap wasn't tightened properly so it was leaking a but there, so check that if anyone gets one.. so after going through the process.. my clutch still has the play AND is super stiff. not sure what went wrong of if my slave went out during the process. i only applied 12psi to the system. not sure what to do next.. trying to see what may have happened.. __________________ "sevens_ix"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode