|
One inaccuracy. I do not have my OEM pressure/boost sensor routed from the UIM nipple under the BAC. That nipple feeds both OEM BOV and AEM boost gauge. The OEM pressure sensor is routed to/from the cold side turbo splitter, which also is routed to my MBC and then from that to my wastegate.
What I noticed today is that idle jumps up about 500RPM when I pull the hose off the UIM to BOV and the idle evens out. Also if I pull the hose off the OEM pressure sensor or unplug the pressure sensor there is no change in idle.
FSM says to hook up a pressure tester to 100mmHG, turn ignition switch and check voltage. Can I simply blow in the pressure sensor and read the voltmeter?
TPS testing:
Narrow: .8 as I go to WOT it will read once at 1.06 then go into OL and then pick up and have one reading of 6.4 where it will hold
Full: .661 closed and as it goes to WOT it will range up to 3.8, then go into OL and pick back up 4.43 and hold.
__________________
Quote:
|
Originally Posted by yzf-r1
Take your pathetic ultimatums and stupid "AOL" comments and shove them straight up your ass, you little punk. You avatar is gay as well....
|
1990 Vert/ S5-JDM 13BT (rebuilt but with issues I'm working out). Rtek N370 1.7, 550/800 injectors, FD fuel pump, RB REV TII exhaust, Tein springs and Illuminas
|
04-26-2013, 03:29 PM
Threaded Mode