Monkman33's Long and Slow "Process"

[Monkman33]

I finally got back to work a little bit ago and was able to start purchasing parts for the FD again so here is the new pile of goodies:
ACT HD Pressure Plate w/ SS Disk. ACT Pro-Lite Flywheel. Innovate TC4 and LC1. Adaptronic e1280s.





flywheel installed:



IRP informed me that they installed a new pilot bearing, but I didn't do a good job of keeping it from getting dirty and there was some noticeable dirt/grime in it from sitting near the open end of my garage on a couple windy days. I just didn't think to cover that spot with tape. So I opted to pop in a new one and seal it up this time.