Naomi: Can't keep a good bitch down!

Sharingan 19 · 08-20-2013, 01:12 PM

Finally got around to getting the V-mount fabbed up, no easy task as this is my daily, but when there's a will, there's a way. While I had the basic concept and most of the parts necessary, the devil is in the details and I did not possess the welding skill to make it happen. So I enlisted the help of a fellow forum member, and this was the mock up.

More details on the K-Tec V-mount setup can be found here: http://www.rx7club.com/showthread.php?t=933572

08-20-2013, 01:12 PM	#33
Sharingan 19 Rotary Fanatic Join Date: May 2010 Posts: 138 Rep Power: 16	V-mount Fab Part 1 Finally got around to getting the V-mount fabbed up, no easy task as this is my daily, but when there's a will, there's a way. While I had the basic concept and most of the parts necessary, the devil is in the details and I did not possess the welding skill to make it happen. So I enlisted the help of a fellow forum member, and this was the mock up. More details on the K-Tec V-mount setup can be found here: http://www.rx7club.com/showthread.php?t=933572

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode