New project: 1976 Cosmo RX-5

[GySgtFrank]

Originally Posted by djmtsu

From what i know, the FC subfrsme is too wide. I will be utilizing FB big bearing front spindles and struts. This will require wheel adapters in the rear, but thats fine. If someone would measure the mounting point width of an FB/FC subframe for me, I'd have confirmation!

Hmmm. It just so happens that I have one sitting in the back of the pickup at the moment. Be right back....

... the front mounting holes are 31 inches center to center and rear holes are 31 5/8 inches center to center. If Whizbang can shoehorn one under an RX-2 I would think an RX-5 should be doable.