Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-23-2013, 04:17 PM   #11
Tegheim
Rotary Fanatic
 
Join Date: Feb 2011
Posts: 210
Rep Power: 15
Tegheim is on a distinguished road
I have been thinking about the intake. I would want to have tapered runners, but because "someone" decided to lower the entire body over the frame, there isn't much space above the engine.
This means that I have to make a turn on 156.5grd pretty tight around the engine and land on the block. The options are to cast runners in plastic, carbon fiber or aluminum perhaps?

Today I continued to mod my intermediate irons for more bearings.
First I layed a the intermediate and clamped it. Then either front or rear iron onto to indicate the centrum.




Machined two new very tight dowels. As tight as possible.
Even then you can move the plate 0.015mm in both directions. I alinged in the middle of the play.






Tegheim is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:28 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com