New project: 1976 Cosmo RX-5

Johnny_K · 03-12-2014, 11:38 AM

Pics of rebuild.

Rotor cleaned and springs labeled

Permatex going on prior to Atkins housing o ring

Carefully installing o ring

Lubing up the rotor in preparation for the seals

Spring installed followed by the side seal

Rotor on rear housing

Rotor lubed for eshaft and corner seals and springs going in

Followed by the eshaft

Center iron going on

2nd rotor on, inspecting placement of seals

Front iron going on

How we ended the night

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-12-2014, 11:38 AM	#11
Johnny_K Rotary Fanatic Join Date: Jun 2013 Posts: 225 Rep Power: 13	Pics of rebuild. Rotor cleaned and springs labeled Permatex going on prior to Atkins housing o ring Carefully installing o ring Lubing up the rotor in preparation for the seals Spring installed followed by the side seal Rotor on rear housing Rotor lubed for eshaft and corner seals and springs going in Followed by the eshaft Center iron going on 2nd rotor on, inspecting placement of seals Front iron going on How we ended the night