Tegheim - Home made 4 rotor Wolvo 142

Tegheim · 03-25-2014, 11:11 AM

Not much is happening at the moment.

I shortened my steering rack at last. Cut 220mm of an let 200mm be left.

Took some M24-nuts and machined out the threads. Then put them over my 4-link rods for adjustments later on. Just a little work with the TIG, and they are ready for some paint.

Are going with these 15.99mm solid dowels straight through the engine. Better off than the OEM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-25-2014, 11:11 AM	#1
Tegheim Rotary Fanatic Join Date: Feb 2011 Posts: 210 Rep Power: 15	Not much is happening at the moment. I shortened my steering rack at last. Cut 220mm of an let 200mm be left. Took some M24-nuts and machined out the threads. Then put them over my 4-link rods for adjustments later on. Just a little work with the TIG, and they are ready for some paint. Are going with these 15.99mm solid dowels straight through the engine. Better off than the OEM.