Lighter = Faster (N/A build thread #2)

[infernosg]

I got the engine and ECU synchronized and calibrated the fuel level sensor on Saturday. Sunday morning I primed the fuel pump for the first time to make sure there weren't any leaks. Fortunately there were none so everything was looking good for a Sunday afternoon start up. I pushed the car out of the garage, enabled the injectors, primed the fuel pump, hit the starter, and... nothing. Maybe one or two little bumps of ignition but no start.

Time to pull the plugs to look for signs of fuel. I pull the L1 plug and it's bone-dry; not a whiff of gasoline. I pull the L2 plug and immediately there's a strong fuel odor, so the front rotor isn't getting any fuel but the rear is. I've already verified the injectors are good by hooking them up to a 12V power source so I broke out the multimeter and started testing for continuity:

Injector to sub-harness break-out connector: "Beep"
Injector to engine-side bulkhead connector: "Beep"
Injector to ECU: "Silence"

It turns out 3/4 wires in the sub-harness connector were wired incorrectly. After de-pinning and correctly re-pinning that connector there's continuity from the ECU to the injector. Just to be sure I also went back and checked the ignition wires. Fortunately those are all good.