ROAR RX-8 Grand Am Koni ST Car

NeuroSpeed · 09-15-2008, 11:33 AM

And now only a few things left to do!

Install the slave cylinder and driveshaft. Install the custom made exhaust that we build in-shop. Make sure all the lines are hooked up, and put fluids in everything and bleed the brakes and clutch. Install the Axial Flow short-shifter. Install the transponder. Install the window net and center net.

Start the motor up, make sure there aren't any leaks anywhere. Make sure the AiM dash is recording all the data it needs to. Put the wheels on.

And now we have another race car!

-- Adam

Again, sorry about the lack of pictures for now but I will post up when I can get my grubby hands on a camera.

09-15-2008, 11:33 AM	#2
NeuroSpeed SuperDuper Awesome Member Join Date: Aug 2008 Location: Roanoke, VA Posts: 19 Rep Power: 0	Whew.. 10,000 character limit. And now only a few things left to do! Install the slave cylinder and driveshaft. Install the custom made exhaust that we build in-shop. Make sure all the lines are hooked up, and put fluids in everything and bleed the brakes and clutch. Install the Axial Flow short-shifter. Install the transponder. Install the window net and center net. Start the motor up, make sure there aren't any leaks anywhere. Make sure the AiM dash is recording all the data it needs to. Put the wheels on. And now we have another race car! -- Adam Again, sorry about the lack of pictures for now but I will post up when I can get my grubby hands on a camera. __________________ Roar Racing Koni Challenge NASA (SE/MA)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode