Edelbrock 600 (1406) & 6p 13B

Rogue_Wulff · 10-07-2008, 01:06 AM

Pulley can go on any of 4 different ways. Perhaps newer engines only allow for one way to install the pulley, but this is an '84 6P 13B.
The RB intake blocks access to one of the bolts holding the inspection cover, so I can't line it up using the flat spot on the flywheel. I've got it very close to being timed right. Once I get it in the ball park, I can reset the pulley, so I can fine tune it with a timing light.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-07-2008, 01:06 AM	#13
Rogue_Wulff Non Member Join Date: Jun 2008 Posts: 310 Rep Power: 18	Pulley can go on any of 4 different ways. Perhaps newer engines only allow for one way to install the pulley, but this is an '84 6P 13B. The RB intake blocks access to one of the bolts holding the inspection cover, so I can't line it up using the flat spot on the flywheel. I've got it very close to being timed right. Once I get it in the ball park, I can reset the pulley, so I can fine tune it with a timing light.