Question about single turbo vacuum diagrams

speedjunkie · 10-22-2008, 08:16 PM

Well I think I may have figured out the problem. One of the settings in the boost controller allow it to only go up to 14psi, so I switched it to allow it to go above and according to the boost controller I got up to 15.5psi today. According to my boost gauge I only got about 13psi, but my tuner said my boost gauge was off sometimes. I'm not sure why it would be off, especially now since it's reading from near the map sensor.

I also switched the line on the side of the wastegate back to the T going to NC and the IC piping.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-22-2008, 08:16 PM	#17
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	Well I think I may have figured out the problem. One of the settings in the boost controller allow it to only go up to 14psi, so I switched it to allow it to go above and according to the boost controller I got up to 15.5psi today. According to my boost gauge I only got about 13psi, but my tuner said my boost gauge was off sometimes. I'm not sure why it would be off, especially now since it's reading from near the map sensor. I also switched the line on the side of the wastegate back to the T going to NC and the IC piping.