Edelbrock 600 (1406) & 6p 13B

Rogue_Wulff · 11-20-2008, 02:40 AM

Jeff, is the carb mounted sideways, as would be typical on a rotary, or in the standard V8 manner with the primaries towards the front of the car?
That is sorta an important item, to give a good idea where to start troubleshooting.
If the carb is mounted with the primaries facing the front like a typical SC application, try lowering the floats. Edelbrock suggested I lower mine to 1/2", and if that didn't solve my problem, try the "Off road" needle/seat assemblies with the springs.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-20-2008, 02:40 AM	#1
Rogue_Wulff Non Member Join Date: Jun 2008 Posts: 310 Rep Power: 18	Jeff, is the carb mounted sideways, as would be typical on a rotary, or in the standard V8 manner with the primaries towards the front of the car? That is sorta an important item, to give a good idea where to start troubleshooting. If the carb is mounted with the primaries facing the front like a typical SC application, try lowering the floats. Edelbrock suggested I lower mine to 1/2", and if that didn't solve my problem, try the "Off road" needle/seat assemblies with the springs.