|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
12-19-2008, 11:50 AM
|
#15 |
|
Rally Fanboy
Join Date: Feb 2008
Location: New York
Posts: 147
Rep Power: 18  |
Okay thanks, I am getting a clearer idea now. But I am still unsure how the seal seats/does not seat with the port work. I may run the motor and see whether or not it eats coolant.
I found a picture of the internals after the port work was initially done. To me it looks like what you just described, where the seal still has a place to sit and shouldn't leave the groove.  
__________________
Last edited by staticpat; 12-19-2008 at 11:54 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode