ports not matching from engine to intake

Rogue_Wulff · 12-19-2008, 03:52 PM

If you are refering to the fact that the ports in the engine are much taller than the ports in the intake (center iron), then don't worry about it. This is by design. The stock intake was like that, as is the RB holley style intake.
FWIW, I have a GSL-SE 6 port engine using that same RB intake, topped with an Edelbrock 600 CFM (1405) carb, and it rocks. Even with 216K on the engine, it still runs strong.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-19-2008, 03:52 PM	#3
Rogue_Wulff Non Member Join Date: Jun 2008 Posts: 310 Rep Power: 18	If you are refering to the fact that the ports in the engine are much taller than the ports in the intake (center iron), then don't worry about it. This is by design. The stock intake was like that, as is the RB holley style intake. FWIW, I have a GSL-SE 6 port engine using that same RB intake, topped with an Edelbrock 600 CFM (1405) carb, and it rocks. Even with 216K on the engine, it still runs strong.