Go Back   Rotary Car Club > Tech Discussion > RX-7 1st Gen Specific (1979-85)

RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-11-2009, 09:44 PM   #3
Rotarydave
Rotary Nut Case
 
Join Date: Jan 2009
Location: Cibolo, TX
Posts: 273
Rep Power: 17
Rotarydave is on a distinguished road
If you look up the clutch from any parts store ie Mazda trix you will find out that both cars use the same clutch there for your spline question would be moot, as for the tranny question they are interchangeable the only issue you will see could be related to rear end gear ratio as some SEs have a different ratio than the 12a cars, You do not need to change the flywheel of your engine because you are using this tranny.
Rotarydave is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:10 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com