Cerberus Project

vex · 03-09-2009, 10:09 PM

Did a little more work:

Installed 6-Port Induction Inserts.

Finished cleaning all the housings and irons.

Found the limit of increasing the port opening of the upper intake. It's an 1/8"

Pile of stuff that came off the car and will either be sold, scrapped, or re-installed (like the water pump and housing)

Some more.

New parts to be installed.

Oil Pan prepped for welding the oil return bung for the turbo.

I'm still a little curious on what I should do with the BAC. Should I keep it? Should I scrap it? I just don't know. I'm tempted to just scrap it and have a friend either weld it shut or I go get a block off plate cut for it. I just don't know. Any suggestions?

03-09-2009, 10:09 PM	#11
vex RCC Loves Me Not You Join Date: Jul 2008 Location: Influx. Posts: 2,113 Rep Power: 20	Did a little more work: Installed 6-Port Induction Inserts. Finished cleaning all the housings and irons. Found the limit of increasing the port opening of the upper intake. It's an 1/8" Pile of stuff that came off the car and will either be sold, scrapped, or re-installed (like the water pump and housing) Some more. New parts to be installed. Oil Pan prepped for welding the oil return bung for the turbo. I'm still a little curious on what I should do with the BAC. Should I keep it? Should I scrap it? I just don't know. I'm tempted to just scrap it and have a friend either weld it shut or I go get a block off plate cut for it. I just don't know. Any suggestions? __________________ The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode