Help me make it to DGRR! Car will not rev...

Max777 · 05-01-2009, 12:37 AM

I almost got it!!!

Ok, so I was looking around, and decided to mess with the throttle body.

My "Fast idle cam" was way out of adjustment, at 75* it was between the 30 and the 70 mark. I got that adjusted, then adjusted the gap in the primary butterfly to .018"

After that, I plugged in the RE-Tested and cleaned BAC valve, and all worked great, my car could now rev with the BAC valve just fine, and ran better than my first outing.

My current problem: The engine stalls when I pull to a stop.... this is now with the Timing and TPS adjusted, and BAC plugged in and functioning.

05-01-2009, 12:37 AM	#25
Max777 Pirate Join Date: Mar 2008 Location: Central IL Posts: 1,323 Rep Power: 19	I almost got it!!! Ok, so I was looking around, and decided to mess with the throttle body. My "Fast idle cam" was way out of adjustment, at 75* it was between the 30 and the 70 mark. I got that adjusted, then adjusted the gap in the primary butterfly to .018" After that, I plugged in the RE-Tested and cleaned BAC valve, and all worked great, my car could now rev with the BAC valve just fine, and ran better than my first outing. My current problem: The engine stalls when I pull to a stop.... this is now with the Timing and TPS adjusted, and BAC plugged in and functioning. __________________ Rotaries:They are NOT that complicated!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode