FC3S Murray's never ending build.

FC3S Murray · 06-28-2009, 08:38 PM

So Kevin Landers may have a rotor for me...I have a another on standby BUT would like to buy from kevin.

I have a quick question regarding side seal clearancing: So do you put one end of the side seal all the way against one of the corner seal eyelets and THEN clearance the other end? I feel stupid but I was checking some of my 50 side seals I have that are practically new and could not get the little fucker to stay still while clearancing one end. It would just slide slightly obviously screwing up my measurement.

06-28-2009, 08:38 PM	#10
FC3S Murray frustrated! Join Date: Apr 2009 Location: Montana Posts: 611 Rep Power: 17	So Kevin Landers may have a rotor for me...I have a another on standby BUT would like to buy from kevin. I have a quick question regarding side seal clearancing: So do you put one end of the side seal all the way against one of the corner seal eyelets and THEN clearance the other end? I feel stupid but I was checking some of my 50 side seals I have that are practically new and could not get the little fucker to stay still while clearancing one end. It would just slide slightly obviously screwing up my measurement. __________________ Same pig, new soul

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode