Custom intake manifold build up

20b 3rd gen · 08-15-2009, 06:24 PM

Nice looking Bryan im going to have to stop by and check it out

Bryan@BNR · 08-15-2009, 10:14 PM

I took it for a spin today and I see a loss in bottom end. It seems to pic up above 5500 when it hits full boost. We shall see when it goes to the dyno again. Still have to put in the 2nd fuel pump, install the 1000cc primaries and then the turbo.

Lots of work!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-15-2009, 06:24 PM	#1
20b 3rd gen Rotary Fanatic Join Date: Mar 2008 Location: Calera, AL Posts: 187 Rep Power: 18	Nice looking Bryan im going to have to stop by and check it out

08-15-2009, 10:14 PM	#2
Bryan@BNR Rotary Fanatic Join Date: Feb 2008 Posts: 302 Rep Power: 18	I took it for a spin today and I see a loss in bottom end. It seems to pic up above 5500 when it hits full boost. We shall see when it goes to the dyno again. Still have to put in the 2nd fuel pump, install the 1000cc primaries and then the turbo. Lots of work!