Any local Bham rotorhead want to do dinner on thursday??

SPICcnmFD · 09-13-2009, 08:03 PM

It made 392hp. I pulled it 5 times and it made between 390-392 every pull no matter what I did. I leaned it out to where I felt comfortable, then ran the timing up 2-3 deg and all it did was run the knock up higher so I backed it back down to where it was and richened it back up and just left it.

It was a crappy day, it was raining so the humidity was awful and his dyno was reading 60% humidity which was I don't see how that could be right, and Blake agreed. I think it'd make 400 on a good day, but it's not going to make much more than what it did.

09-13-2009, 08:03 PM	#11
SPICcnmFD Rotary Fanatic Join Date: Feb 2008 Location: B'ham, AL Posts: 329 Rep Power: 18	It made 392hp. I pulled it 5 times and it made between 390-392 every pull no matter what I did. I leaned it out to where I felt comfortable, then ran the timing up 2-3 deg and all it did was run the knock up higher so I backed it back down to where it was and richened it back up and just left it. It was a crappy day, it was raining so the humidity was awful and his dyno was reading 60% humidity which was I don't see how that could be right, and Blake agreed. I think it'd make 400 on a good day, but it's not going to make much more than what it did. __________________ 1993 Rx-7 SM2 #11 At the local AutoX: http://www.youtube.com/watch?v=9VOSQkkSLQs Speed for Sale shootout 2007: http://www.youtube.com/watch?v=JiqlyAkGmpg A few laps at Barbers: http://www.youtube.com/watch?v=6_h5q...x=0&playnext=1

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode