Problems after changing fuel setup.

[Pettersen]

Changed the fuel system on my FC NA and it dies everytime the water temp hit's 50 C, seems like fuel delivery is just cut, no studder or anything, and i can't start it up before it has cooled down below 50 again.

The engine setup:

4 port streetport, 13B non turbo, Apexi power fc, ran fine at all water temps with the previous fuel system.

The previous fuel system:
stock 460 primary inj and stock 460 secondary inj with stock resistor box.
Stock fuel rails and fpr.

New fuel system:
ID 1000 primary inj, removed resistor box, no sec injectors.
Stock primary fuel rail, AEM fpr.
Changed settings in the pfc to 100% transition and set the sec injectors to 0, also changed the setting in inj vs batV as per the info on the injector dynamics site.