Need custom engine mounts

speedjunkie · 03-26-2011, 11:35 PM

Well I would recut them, but to answer Brian's question, no you can't cut the Noltecs because they have metal on both sides of the mount. I had some Delrin or Polyurethane mounts that would work if I cut them down but I traded them to my roommate a couple years ago. I think he still has them but he probably lost them again haha.

I thought about using lumber but I figured they might catch fire with the heat LOL.

On a serious note though, I did buy a few hockey pucks to try but two of them together are too thick and one is too thin. I was laughing my ass off on Rice Racing's thread when I read the part about hockey pucks LOL. I'd much rather have real mounts anyway, but I figure Delrin or Poly isn't much different anyway, it's not like our mounts are electronic like the Audi mounts lol.

03-26-2011, 11:35 PM	#6
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	Well I would recut them, but to answer Brian's question, no you can't cut the Noltecs because they have metal on both sides of the mount. I had some Delrin or Polyurethane mounts that would work if I cut them down but I traded them to my roommate a couple years ago. I think he still has them but he probably lost them again haha. I thought about using lumber but I figured they might catch fire with the heat LOL. On a serious note though, I did buy a few hockey pucks to try but two of them together are too thick and one is too thin. I was laughing my ass off on Rice Racing's thread when I read the part about hockey pucks LOL. I'd much rather have real mounts anyway, but I figure Delrin or Poly isn't much different anyway, it's not like our mounts are electronic like the Audi mounts lol.