THIS is going inside my FB...

[-xlr8planet-]

Originally Posted by warwickben

you need to go step by step with this please. my buddy is doing a rhd swap on his fd and is willing to give me the parts needed.

i would most likely use the cluster area only then build the rest , they way you have it mocked up now, do you have any problem seeing where the gauges will be.


also as a side note. how do i get a mph gauge to work with a sa tranny

To get the FD cluster to work you need to "feed" it with the correct inputs. I´ve been over the diagrams and some FB sensors can made to work, while others need to be replaced (oil press for example).

To get the speedometer to work, you have to make one piece out of the tranny output of the FB (mech) and the on of the FD (speed sensor) Then you send out the dash to get re-calibrated.

Everything seems to fit. No cutting needed