|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
06-24-2008, 08:44 PM
|
#2 |
|
Rotary Fanatic
Join Date: Feb 2008
Location: Metuchen, NJ
Posts: 249
Rep Power: 18  |
They are m6 x 1.0. Helicoils are fine, just make sure you thread them in enough so that part of the coil does not stick up past the oil pan mating surface. I always run a tap first because the built up silicone and grime causes the bolts to easily strip. I also used the Moroso stud kits will good results. Make sure you lay the pan and brace on first, then screw in the studs.
__________________
Providing rotary engine rebuilds, porting, turbo installs, parts installations, full maintenance, etc. We work on all cars. www.irperformance.com www.myspace.com/rotaryexperimentseven irperformance@live.com 732-662-1794 |
|
|
| Bookmarks |
|
|
Threaded Mode